22
ASSEMBLY AND INSTALLATION
6-4 ASSEMBLING CHECK
Initialization Operation
Turn on the main power switch on the AC unit.
Initialization will begin after the uorescent lamp on the billboard lights up and the RINGWIDE startup screen
displays on the monitor. The steering wheel will rotate left and right, then return to the middle.
Once the initialization is complete for RINGWIDE and the internal system, the advertising (standby) screen will
display on the monitor.
Do not turn the steering wheel or touch the buttons until the initialization operation has successfully completed.
Doing so could affect the handling of the steering wheel and cause problems.
Use TEST MODE to check whether everything has been assembled correctly and the IC board is functioning
normally.
See the RINGWIDE Service Manual for details on SYSTEM TEST MODE and “9-3 GAME TEST MODE” for
details on GAME TEST MODE.
To Next Page
Loading...
