38
EXPLANATION OF TEST AND DATA DISPLAY
9-3-3 INPUT TEST
1
On the GAME TEST MODE screen, select INPUT TEST and press the TEST Button. The INPUT TEST
screen appears.
Select INPUT TEST to display the following screen and check the status of input devices.
This test should be used periodically to check that each input device is functioning correctly.
2
Manipulate each switch, etc., to check screen display.
Test the STEERING, GAS and BRAKE controls to ensure that they are functioning properly and that the parameters
change smoothly as each input device is operated. The STEERING value will decrease when the steering wheel is
turned to the left and increase when turned to the right.
If the buttons turn ON when pressed and OFF when released, they are working normally.
3
When all checks are completed, press the TEST Button and the SERVICE Button simultaneously. The
GAME TEST MODE screen reappears.
Input Control
INPUT TEST
TEST OFF
SERVICE
OFF
SW1 OFF
SW2 OFF
START OFF
VR SW1 OFF
VR SW2 OFF
VR SW3 OFF
VR SW4 OFF
SHIFT1 OFF
SHIFT2 OFF
SHIFT3 OFF
SHIFT4 OFF
STEERING **H
ACCEL **H
BRAKE **H
SELECT WITH SERVICE BUTTON AND PRESS TEST BUTTON
SHIFT 1-4
STEERING
START
VR SW1 (Red)
VR SW2 (Blue)
VR SW3 (Yellow)
VR SW4 (Green)
BRAKE
ACCEL
To Next Page
Loading...
