55
CONTROL PANEL (STEERING WHEEL MECHANISM)
11-2 VOLUME REPLACEMENT
1
Turn the power off.
2
Remove the 2 screws and take off the upper door on the back of the cabinet. (See 10-2.)
3
Remove the wire connector coming out from the volume. The wire for the upper drive board volume has
an “UP” tag, and the wire for the lower game board volume has a “DOWN” tag.
4
Remove the 2 screws that fasten the VR bracket, and remove the VR bracket together with the volume.
5
Remove the 2 fastening screws from the gear holder, and pull out the gear holder from the volume axis.
6
Remove the volume from the VR bracket and replace it.
7
Refer to “11-1 VOLUME ADJUSTMENT” to install the replacement volume and check it after installation.
Disconnect the connector.
VOLUME
220-5753
VR BRACKET
NUT, WASHER included with volume
SETSCREW (2)
M3 x 8
GEAR HOLDER
GEAR 64
To Next Page
Loading...
