Replacement Method
1
Turn off the power switch of the cabinet.
2
Remove 2 screws, and remove the potentiocover.
3
Undo the connector of the volume to be replaced.
4
Remove the screw that fastens the potentiobase. (See the gure above.)
5
With the volume still attached, remove the potentiobase.
6
Remove the base and the gears, and replace the volume.
7
After turning on the power switch, check the volume as described in the “Adjustment Method” section
above.
8
Return removed parts to their original locations.
TRUSS SCREW (2), chrome
M4 x 8
POTENTIOBASE
POTENTIOCOVER
To Next Page
Loading...
