78
PERIODIC INSPECTION
Cleaning the Cabinet Surfaces
When the cabinet surfaces become dirty, remove stains with a soft cloth soaked in water or diluted (with water)
chemical detergent and then wrung dry. To avoid damaging the nish, do not use such solvents such as thinner,
benzene, etc. (other than ethyl alcohol) or abrasives (bleaching agent and chemical dust-cloth).
Some general-purpose household, kitchen, and furniture cleaning products may contain strong solvents that degrade
plastic parts, coatings, and print. Before using any cleaning product, read the product's cautionary notes carefully
and test the product rst on a small area that is not highly visible.
Seat (Greasing to Seat Rail Portion)
Move the seat to the rearmost position and apply spray greasing to the portion shown at the right once every 3
months by using NOK KLUBER L60 or GREASE MATE SEGA PART No. 090-0066.
After greasing, move the seat a few times forward and backward so as to allow the grease to be applied all over
uniformly.
Be sure to wipe grease which attaches to the surfaces of the protect rubber on the seat rail, or any excess grease.
17
Apply grease.
To Next Page
Loading...
