Sega Racing Classic - Software Installation Procedure

83
TROUBLESHOOTING
18-3 SOFTWARE INSTALLATION
● LookingdirectlyatthelaseroftheDVDDRIVEmaycauseeyeinjuries.Donot
look inside the DVD DRIVE.
● When
connectingtheconnectors,besuretoattachthemcorrectly.Thereisonly
one correct way in which they must be connected. Attempting to connect them
incorrectly may cause damage to the pins on the connectors, and cause electric
shock,
shortcircuitorre.
●StaticelectricityfromyourbodymaydamagesomeelectronicsdevicesontheIC
board. Before handling the IC board, touch a grounded metallic surface so that
the static electricity can be discharged.
●Do
notturnoffthepowertotheDVDDRIVEwhenitsaccesslampisonor
ashing,asthiscouldcausedamagetothedevice.
●Afterthepowersupplyisengaged,theDVDDRIVEtraywillnotcomeoutfor
about30secondsevenifyoupresstheswitch.ThisisduetoDVDDRIVE
initialization.
●TheDVDDRIVEtraycancomeoutorreturnonlywhilethepowersupplyis
engaged. The tray cannot be opened or closed while the power is off.
●Do
nottouchthelensinsidetheDVDDRIVE.Doingsomaypreventitfrom
reading accurately.
●Even
afterthesoftwarehasbeeninstalled,storetheDVDsoftwarekit,DVDDRIVE
and DVD wire (for installation) in a secure location.
●If
foranyreasoninstallationcannotbecompleted,anerrorisdisplayed.Referto
theservicemanualandtakecorrectiveaction.
●StoretheDVDDRIVE,USBwireforinstallationandDVDDRIVEkitinalocation
free of dust and cigarette smoke. The DVD DRIVE may not be able to read data
due to its condition.
If the software is uninstalled or deleted from the game board (RINGWIDE) for some reason, follow the procedures
below to reinstall it.
If several cabinets are connected for network play, the settings will need to be recongured for network play,
because the software will have the default settings when installed.
1
Turn off the power switch of the cabinet that loaded with RINGWIDE.
2
Prepare the DVD DRIVE and the following accessories. (See Chapter 5.)
- USB wire
- DC power supply wire
- DVD software kit
18