Sega Snakes & Ladders - Cabinet Securing and Levelling; Adjusting Cabinet Level

ASSEMBLY AND INSTALLATION
22 23
ASSEMBLY AND INSTALLATION
6 6
• Makesurethatalltheadjusterscontacttheoor.Otherwisethecabinetcould
move,causinganaccident.
• Provideaventilationspaceatleast15cmwidebehindthe cabinet.Thereare
ventilation holes on the backof the cabinet. Do not blockthe ventilation holes.
Doingsocould trap heat inside resultinginre.It could also resultinequipment
damageorcausepartstobecomeexhaustedprematurely.
The product is equipped with 2 casters and 2 adjusters.
When installation position / site has been determined, have the adjusters come in direct contact with the oor. Adjust
the adjusters to eliminate any movement in the cabinet.
1 Move the product to the installation site.
2 Bring the adjusters into direct contact with the oor. Use a wrench to align the height of the adjusters until the
cabinet is perfectly level.
3 After setting, turn adjuster nuts upwards to tighten them and secure adjuster heights.
ADJUSTER
Fasten the nuts in an
upward direction.
Keep Casters at floor level -
Adjust to come into contact with floor
ADJUSTER
CASTER
6-2 FIXATION TO SITE
CASTORS
ADJUSTERS
150mm
• Provideaventilationspaceatleast15cmwidebehindthe cabinet.Thereare
ventilation holes on the backof the cabinet. Do notblockthe ventilation holes.
Doingsocould trap heat inside resultinginre.It could also resultinequipment
damageorcausepartstobecomeexhaustedprematurely.
Leave a 150mm gap for ventilation