Sega Snakes & Ladders - Controller Greasing Procedure

CONTROL UNIT
48 49
CONTROL UNIT
10 10
6
Ret the pot to the VR bracket keeping the pot in the same orientation as when initially removed.
7
Fit the Gear to the pot shaft taking care not to overtighted the xing as this could damage the thread inside
the gear.
Gear
8
Manually center the pot and reposition it back into the controller mecha and secure.
VR Bracket
Pot
Incorrect Incorrect
correct
• Besuretousethedesignatedgrease.Usingundesignatedgreasecancause
partsdamage.
• Donotapplygreasetolocationsotherthanasspecied.Doingsomaycreate
ariskofoperationalproblemsanddeteriorationofparts.
• Thedesignatedperiodsforgreasingserveonlyasaguide.Wheneverthereare
squeaksorotheranomalies,applygreaseatdesignatedlocations.
Use spray grease once every three months to grease up the gear mesh portion of the constituent parts.
Use "Grease Mate" (part number 090-0066) for the spray grease.
10-2 GREASING
V.R. GEAR MESH PORTION