EasyManua.ls Logo

Sega Snakes & Ladders - Feature Reel; Tracker; Changing Tracker;Reel Band

Sega Snakes & Ladders
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FEATURE REEL / TRACKER
50 51
FEATURE REEL / TRACKER
11 11
11 FEATURE REEL / TRACKER
The main feature of this game is the feature reel or tracker.
Each time a handle is pulled, the cfeature reel will revolve at a speed chosen by the player when pulling down on the
handle. The speed of the reel is determined using the gauge on the Control Panel. When a player pulls down on the
handle the gauge increases accordingly. The further a handle is pulled down the faster/longer the reel will spin.
For information of replacing the LED's within the feature reel please refer to Chapter 13 - Lamps and Lighting in this manual
.
The Game is presented in three formats, a £2/€2/$2 game a £1/€1/$1 game and a 50p/50c/50¢ game. The
denomination of the game is determined by the feature band. By default the games are shipped from the
maunfacturers with the £1/€1/$1 band fitted. The £2/€2/$2 and 50p/50c/50¢ bands are both supplied in the
installation kit box alongside this manual and the billboard.
11-1 CHANGING THE TRACKER / REEL BAND
2
Remove the Ladder Artboard buy unscrewing the (8) M4x30 MSCR PH BLK from the outer edges.
1
Remove the power from the cabinet and disconnect the power lead.
Remove the (8) M4X30 MSCR PH BLK screws
from the locations shown.
Take care when removing the final fixing as the
ladder artboard may become unbalanced and topple
over.
3
RemovetheLadderlightboard-Unscrewthesinglexingwhichsupportstheladderlightboard.Carefully
tilt the board towards you and rest it on the Console cabinet. Disconnect the harnesses to the ladder light board
located at the lower left hand corner. Lift out the board and place it carefully to one side.
4
Removing the Tracker/Reel Band - Locate the (4) M5 Hex nuts positioned at each corner of the Tracker
assembly and lossen. Locate and disconnect the Tracker harness.
Carefully tilt the ladder light board
forward and remove the connections
located at the lower left hand corner
Remove the (1) fixing which supports
the Ladder light board.
Lossen (Not remove) the (4) M5 Hex
Nuts from the Tracker brackets
Disconnect Harness

Related product manuals