Sega Snakes & Ladders - Coin Handling; Handling Coin Jams; Cleaning the Coin Selector

COIN HANDLING
54 55
COIN HANDLING
12 12
If the coin is not rejected when the REJECT button is pressed, open the coin chute door and open the selector gate.
After removing the jammed coin, put a normal coin in and check to see that the selector correctly functions.
The Coin Selector should be cleaned once every 3 months.
When cleaning, follow the procedure below:
12-1 FIG 1
● Removeandcleansmearsbyusingasoftclothdippedinwaterordiluted
 chemical detergentandthensqueezeddry.
● Neverapplymachineoil,etc.totheCoinSelector.
● AftercleaningtheCoinSelector,insertaregularcoininthenormal 
 workingstatusandensurethattheselectorcorrectlyfunctions.
12-1 CLEANING THE COIN SELECTOR
GATE
Handling the Coin Jam
12 COIN HANDLING
1
2
3
Turn the power for the machine OFF. Open the Coin Chute Door
Remove the Coin Selector from the Coin Chute Door
Open the gate and dust off by using a soft brush (Small soft Paint Brush, etc.)
Remove and clean smears by using a soft cloth dipped in water or diluted chemical detergent and then
squeezed dry.
Remove the CRADLE.. When removing the
retaining ring (E ring) be very careful so as not to
bend the rotary shaft.
Remove stain from the rotary shaft and shaft
receiving portions by wiping off with a soft cloth.
etc.
After wiping off as per previous step, further apply a dry cloth to completely dry the Coin Selector.
CLEANING THE COIN SELECTOR (MECHANICAL).
Once every month, when performing the Coin SW Test, simultaneously check the following:
Does the Coin Meter count satisfactorily?
Does the coin drop into the cashbox correctly?
Is the coin rejected when inserted while keeping the REJECT Button pressed down?
Coin Insertion Test
12-1 FIG 2
12-1 FIG 3
CRADLE
Insert a coin while keeping
the REJECT Button pressed
down and check if it is
rejected.
1
2
3
4