Sega Snakes & Ladders - Lamps and Lighting; Replacing Coin Door Lamp; Replacing Ladder;Winline LEDs

13
LAMPS AND LIGHTING
LAMPS AND LIGHTING
13
62 63
The Coin Door Lamp utilises a 12v 1.2w Wedge Bulb. It is important that you
replace this bulb or any other bulb of that of the same voltage and rating.
Failing to observe this caution may result in PCB failure or possible re hazard.
• When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
• Be sure to use lamps of the designated rating. Using lamps of undesignated
rating can cause a re or malfunctioning.
• There is the danger of short circuits or smoke generation due to deterioration
of insulation in lighting xtures resulting from age deterioration. Check for
anomalies such as the following: Does it smell like something is burning? Is there
socket discoloration? Are any lamps being replaced frequently? Do lamps not
go on properly?
Step 1. Open the Console lid and locate the Lamp Housing
directly behind the Coin Insert Bezel.
Step 2. Hold the Lamp Housing rmly between your index
nger and thumb and gently pull upwards. Do Not try
to remove the Lamp Housing whilst holding the bulb as
the bulb may break causing injury.
Step 3. Once the Lamp Housing has been removed, carefully
hold the bulb between your ngers and pull the Lamp
Housing away.
Do not twist either bulb or Lamp Housing whilst removing the
bulb as this may cause damage to both bulb and or Housing.
Step 4. Simply push-t a replacement bulb of the same type
and follow these steps in reverse to ret.
13-1 REPLACING THE COIN DOOR LAMP
Lamp Housing
Type: Wedge Bulb - 12v, 1.2w
13 LAMPS AND LIGHTING
13-2 REPLACING THE LADDER / WINLINE LED’s
TAKE CARE WHEN ACCESSING THE INTEGRAL PARTS OF THE MACHINE.
MAKE SURE POWER IS REMOVED BEFORE SERVICING.
ONLY TOUCH PARTS WHICH ARE OUTLINED IN THE INSTRUCTIONS BELOW. FAILURE
TO OBSERVE THIS CAUTION MAY RESULT IN INJURY OR COMPONENT DAMAGE.
REMOVING THE LADDER ARTWORK PANEL
2
To access the LEDs remove the Ladder Artwork Panel by unscrewing the (8) M4x30 MSCR PH BLK from
the outer edges.
1
REMOVE THE POWER and DISCONNET THE POWER CABLE
Remove the (8) M4X30 MSCR PH BLK screws
from the locations shown.
Take care when removing the final fixing as the
ladder artboard may become unbalanced and topple
over.
The LED strips are positioned upon each rung of the ladder (including the uprights), The center WIN LINE and the "SUPERWIN" feature at the
top of the Ladder.