Sega Snakes & Ladders - Replacing the Led (Rgb) Pull

13
LAMPS AND LIGHTING
LAMPS AND LIGHTING
13
70 71
4
The LED Strips are adhered into position but the connections are soldered into place. Before removel take
note of the position of the wires. To remove the LED Strips, unsolder the two wires (Yel & Blk). Then
carefully peel away the LED Stirp to remove.
5
On the NEW LED strip, peel off the protective backing and adhere it in place. Resolder the wires in the
same location as when removed.
6
Reassemble following the instructions in Chaper 11 section 1 of this manual in reverse order.
13-6 REPLACING THE LED (RGB) PULL
1
REMOVE POWER from the cabinet and diconnect the POWER LEAD.
2
Remove the Control Panel Acrylic by unscrewing the (4) xing located at each corner of the Console Lid.
3
Locate the LED PCB to be replaced. To remove, press in the latch on the PCB Mount to release. Disconnect
harness and remove. NOTE ORIENTATION OF PCB
4
Clip the NEW LED into place and reconnect the harness (taking note of the orientation IN/OUT)
5
Follow steps 1 to 3 in reverse order to reassemble.
Console Lid
PCB Mount latch
RGB LED PCB
Fixing Points
Fixing Points
Lift Con Pan Acrylic to reveal LEDs