4
The main board is the board on the bottom of the RINGWIDE shield case. A
fter replacing the main board’s
button battery, refer to Step 3 and close the lid.
The button battery that requires replacement can be found on the main board, inside the RINGWIDE shield case.
1
Remove the unit on which RINGWIDE is placed from the game cabinet.
RINGWIDE must be removed still attached to the base (wooden shelf, etc.).
2
Remove 2 screws for the RINGWIDE lid. The screws are on top of the connector side.
3
Slide the lid toward the side with the connectors, and remove it.
401-0070
BUTTON BATTERY (BATTERY LITHIUM CR2032 SONY)
SCREW (2)
M3 x 6, w/at & spring washers
Slide toward the connectors side.
To Next Page
Loading...
