39
ARM MECHANISM
13
PHOTO 13-1f
PHOTO
13-1g
11. The arm on the opposite (left) side can be replaced by following the same procedure.
NOTE: When attaching or removing the mechanism mask as indicated in steps 7 and 9, remember that the slide
direction is different. Slide the mechanism mask away from you to remove it; slide it toward you to attach it.
8. Remove the arm and attach the arm S or L
replacement.
9. Refer to step 7 and reattach the mechanism mask.
Pay special attention to the direction of the U-shaped
notch when attaching.
10. Use a slotted screwdriver to tighten the bolt that
holds the arm in place (which had been loosened).
To Next Page
Loading...
