56
REPLACEMENT OF FLUORESCENT LIGHTING, LAMPS, AND FUSES
16
The provided tamperproof wrench is required for the following procedures.
1. Turn the power off.
PHOTO
16-3a
2. Remove the 2 tamperproof screws, unlock with the
master key and open the back lid.
3. The 2 fuses are located at the back of the left side. When replacing them, make sure that the ratings are correct.
16-3 FUSE REPLACEMENT
• The work must only be carried out by personnel with electrical appliance
knowledge. Shocks and other serious accidents may result if the work is carried
out by unqualified individuals.
• Before performing work, be sure to turn the power off and unplug the electrical
cord from the outlet. Performing the work without turning the power off can
cause an electric shock or short circuit.
• After eliminating the cause of a blown fuse, replace the fuse. Depending on
the cause of the fuse blow, continued use with the blown fuse may cause the
generation of heat and present a risk of fire.
• Be sure to use fuses of the specified rating. Using fuses exceeding the specified
rating may cause fire or electric shock.
PHOTO 16-3cPHOTO 16-3b
To Next Page
Loading...
