SEI NARITA - Step 4-6: Completing the Assembly

E
E
E
E
E
E
E
E
E
(7)
(8)
(8)
E
Figure 4
USE 38PCS ROUND HEAD SCREW(E) AND
4PCS SLICE OF IRON(F) TO ASSEMLBE
MIDDLE BACK PANEL(7) AND SIED BACK
PANEL(8) TO THE UNIT,AS AS FIGURE 4
SHOWN.
Figure 5
ATTACH MAGNET PLATE (J) ON THE
DOOR(R&L) BY USING 2PCS SHORT FLAT
HEAD SCREW.
ATTACH KNOB(L) ON THE DOOR(R&L) BY
USING 2PCS LONG BOLTS (K).
USE 4PCS HINGE (H) AND 16PCS SHORT
FLAT HEAD SCREW (I) TO ASSEMBLED
DOOR(R&L).
INSERT 8PCS SHELF HOLDER (M) INTO
CORRESPONDING HOLES OF MIDDLE
FIXED PANEL(3) ,THEN PUT THE SHELF
PANEL ON IT ,AS FIGURE 5 SHOWN.
Figure 6
INSERT THE FIREBOX FROM THE BACK OF
FIREPLACE. MAKE SURE FIREBOX IS
PRESSED TIGHTLY AGAINST THE
ASSEMBLED UNIT. INSERT 2PCS FLAT
HEAD LONG SCREWS (N) THROUGH
PREDRILLED HOLES ON FIXED WOOD (11)
AND TIGHTEN INTO CORRESPONDING
HOLES ON BACK OF FIREBOX. AS FIGURE
6 SHOWN.
NOW YOUR NEW FIREPLACE IS REDADY
TO USE.
We'd love to hear from you! Email us photos of our products in your home at sei@seidal.com
and we might feature it on our site or use it to model one of our inspirational photos.
"NARITA"MEDIA CONSOLE FIREPLACE
Assembly Instructions
O
(9)
(10)