*note 1 When the watch is charged by any other method than manual winding, such as using KINETIC
ENERGY SUPPLIER, the direct drive indicator hand may move in slightly slower motion.
*n
ote 2 The direct drive indicator hand will stop at the maximum scale value pointing at the ‘M+1’ position.
If the crown is turned after the direct drive indicator hand stops at the ‘M+1’ position, the watch
continues to accumulate power reserve, but the real-time power indicator function stops. If you
want to display the a
mount of generated power
, stop turning the crown, and after the direct drive
indicator hand returns to the power reserve display, start turning the crown again.
Wh
en the electric power is generated without interruption, for example when an electric charger
is used, the direct drive indicator hand will stop and remain pointing at the ‘M+1’ position.
*n
ote 3 After the direct drive indicator hand displays the accumulated amount of generated power, it
returns to the power reserve display.
(Cauti on)
To
enjoy the real-time power indicator function, power generation by manual winding is
recommended as it enables you to check the power generating status.
2.
Real-time power indicator function
How to read the real-time power indicator
Scale marking
0 1 2 3 4 5 6 7 8 9 10
Indication on dial
0 D
Amount of generated power
h=hour(s) min=minute(s)
Standby
position
0
20 min 40 min
1h
1h
20 min
1h
40 min
2h
2h
20 min
2h
40 min
Scale marking
11 12 13 14 15 16 17 18 19 20
Indication on dial
W
M
Amount of generated power
h=hour(s) min=minute(s)
3h
3h
20 min
3h
40 min
4h
4h
20 min
4h
40 min
5h
5h
20 min
5h
40 min
6h
<Display and movement flow of the direct drive indicator hand while charging the watch>
Power reserve
display
Power generation status and generated power display
Power reserve display
Initial status
In-progress
A. While turning the crown
B. When temporarily
stopping turning the
crown
After
approximately 4
seconds since
stopping turning
the crown
After
approximately
1 second since
starting to turn
the crown
A B
✽
The direct drive indicator hand points at
a scale marking between 0 and ”M+1”
according to power generation status.
✽
Th
e point where the indicator
hand starts moving goes up as
generated power increases.
To Next Page
Loading...
