Sekonic LITEMASTER PRO L-478 Series - 2) User Calibration of Measured Value

59
2) UserCalibrationofMeasuredValue
1. Touch the [User Calibration] in the Hardware
SettingscreentodisplaytheUserCalibration
screen.
2. Usingthebuttonof [+0.1EV] or [-0.1EV] at
bottomofscreen,adjustcalibrationvaluein
0.1stepincrements.
*Inthisscreen,itispossibletotakea
measurementanddisplaythevalue,then
adjustbyusingthe+/-0.1EVbuttons.This
willbehelpfulifyouwouldliketomatchthe
measuredvaluetoanothermeterbyreading
thesamelightsource.
3. Touch the [Close]tocompletethesetting
and return to the Measuring screen.
3)AdjustTouchPanelDisplayPosition
1. Touch the [Adjust Touch Panel] in the
HardwareSettingscreentodisplaytheTouch
PanelAdjustingscreen.
2. Awhitecrossmarkwillappearattheupper
left of the screen. Please touch this cross.
Aredcrossmarkwillbedisplayedinthe
touched position.
3. Thesecondwhitecrossmarkwillappear
inanotherposition.Touchitwithngerto
displayaredcrossmarkinthetouched
position.Repeatthistouch-and-display
processeighttimesintotal.
4. Touch the [OK]inthescreensaying[Data
isdeterminedbypressingthe“OK”.]
tocompleteadjustmentsandreturnto
Measuring screen.
Touch the [Cancel]tocanceladjustments.
UserCalibrationScreen
Calibration
value
TouchPanelAdjustingScreen
TouchPanelAdjust
ConrmationScreen
White
cross
(cursor)
Touched
position