2.
For RTC awaken or Sensor awaken, GPS mode will wait for location no more than 150
seconds,
otherwise it will start to send data by dialing immediately, if GPS mode locate within
150s. Time
mode which is set 7 to 30 minutes will quick located within 90s.
3.
Time mode which is set 7 to 30 minutes will go into sleeping mode within 3 minutes. The
device
go into sleeping mode if it is set for 1~6 minutes. Other modes need 6 minutes
for going into
sleeping mode.
Open the device and put on SIM card, then put the magnet on the bottom of the device. Find a place with
metal material in the vehicle, put the device with magnet on it, it is a very easy installation.
Com Port No. Choose right com port and open it
Communication
IP
Set the needed IP and Port
APN Set the needed APN
Equipment No. Setting the equipment NO.
Time correct
Can correct time (Remark: after equipment power off ,the time would not be
kept)
Alarm mode Can set up alarm and to send back the data, can set 4 times at most
Timer mode
Choose close then adopt alarm mode ,choose open ,then the date send back
according to the setting-up time
Week mode
Choose close then adopt alarm mode ,choose open ,then the date send back
according to the setting-up week time
Alarm switch Choose tamper alarm switch open or close
Setting
After setting the parameter, then click setting, after setting succeed ,then
remind you setting succeed ,otherwise remind you setting failure
Read Click read and confirm if the parameter you read is same as your setting-up
Set by Computer
use USB line make the device connect with computer
To Next Page
Loading...