7
How to Install?
By following the instructions step by step you can proceed easily to install SELFSAT-H21D+ / H30D+ by
yourself or with the help of a professional antenna installer.
Step 1: Where to Install?
Bad Quality Singnal Reception
Note
In order to receive a signal from the Satellite, SELFSAT-H21D+ / H30D+ is to be installed in an open
loop space (outside the house or the apartment), in the direction of the satellite towards the equator,
for which, you will need a compass to exactly orient SELFSAT-H21D+ / H30D+ toward the satellite
(Note: please take reference to the table of the Azimuth angles specied in the back pages of this manual)
Make sure that there are no obstacles in front of SELFSAT-H21D+ /
H30D+ which can decrease the signal reception quality, such as buildings, or trees (you may keep in
mind that trees will grow and may block the signal).
In order to be able to x and install your antenna easily you might choose an easily accessible place
without any potential danger for installation.
Think about the way you might pass your cable in a discreet way from the SELFSAT-H21D+ / H30D+
to your Set top Box. The antenna should not be too distant from your satellite receiver; a cable longer
than 30 meters can decrease the quality of the signal.
Before installing your antenna, you check that SELFSAT-H21D+ / H30D+ box contains all the items
listed above in the ‘Box Content’. In the event of any missing parts, please contact your distributor.
To ensure an accurate compass reading, stay away from large
metal objects, specically electrical cables and then make
multiple readings
BAD!BAD!
Install
To Next Page
Loading...
Need help?
General