HE40 Secondary Burn System
REMOVAL & REPLACEMENT
5 Stainless
Steel
Secondary
Air Tubes
Log Retainer
Left & Right Support Angles
Front
Baffle
Rear
Baffle
Rear
Fireplace
Refractory
Left Hand
Side
Fireplace
Refractory
Right
Hand Side
Fireplace
Refractory
FRONT VIEW OF THE INSIDE OF THE HE40 FIREPLACE
ATTENTION! For a thorough cleaning or sweeping of the chimney system from
the inside of the fireplace (due to a steep roof pitch), follow Steps 1 through 9.
Step 3. Remove the right and left support angles by push-
ing upward against the side at the top (with the head of a
screwdriver) until the flange clears the lanced tab (see Fig-
ure 4a). You can also push up on the front baffle to release
the tension on the support angle.
FIGURE 1
Log Retainer
FIGURE 3
Bottom Refractory
FIGURE 2
Log Retainer and Ash Pan
Step 2. Remove the bottom fireplace refractory brick (see
Figure 3).
FIGURE 4a
Lance Tab
LHS
Support
Angle
Lance Tab
Front
Baffle
Step 1. Release the log retainer from its locked posi-
tion by sliding the ash drawer forward. Once unlocked,
lift out the log retainer (see Figure 2).
FIGURE 4b
Unclipped Tab
Figure 4b shows the unclipped left hand side support angle.
Once unclipped, remove both support angles from the air
tubes.
Front
Baffle
To Next Page
Need help?
General
