To Next Page
D
Dennis GallegosJul 31, 2025
Why is my Selva Engine overheating?
- SSamantha PerezJul 31, 2025
If the Selva Engine is overheating, it may be due to clogged water passages. Check and clear any obstructions to ensure proper cooling.
Why is my Selva Engine overheating?
If the Selva Engine is overheating, it may be due to clogged water passages. Check and clear any obstructions to ensure proper cooling.
How to start Selva T25/30 that won't start?
If the Selva Engine will not start, the fuel tank might be empty. Refill the fuel tank and try starting the engine again.
What to do if Selva T25/30 Engine runs irregularly?
If the Selva Engine runs irregularly or stalls, the fuel hose might be incorrectly connected. Ensure the fuel hose is properly connected.
Why engine speed of Selva Engine will not increase?
If the speed of the Selva Engine will not increase, a faulty thermostat may be the cause. Consider replacing the thermostat.
Why is the Selva Engine speed lower than normal?
If the Selva Engine speed is lower than normal, it could be due to a clogged fuel filter. Inspect and clean or replace the fuel filter.
Why does my Selva T25/30 idle unevenly?
If the Selva Engine idles unevenly, the fuel pump might be malfunctioning. Consider inspecting and potentially replacing the fuel pump.
What to do if the starter-motor of Selva T25/30 Engine does not operate?
If the starter-motor of your Selva Engine (mod. with electric start) does not operate, the starter-motor may be defective. Consider replacing the starter-motor.
Details critical safety measures and rules for operating the outboard motor safely.
Section for recording the outboard motor's serial number for future reference and identification.
Outlines fundamental safety precautions and guidelines for operating the outboard motor.
Emphasizes critical safety warnings and precautions related to the propeller's operation.
Identifies and describes the primary parts and components of the remote control box.
Explains the operational functions and controls of the remote control box.
Provides the electrical wiring schematic for outboard motors with manual starting systems.
Details the electrical wiring schematic for outboard motors equipped with electric starting.
Defines symbols used to indicate engine-related warnings and operations.
Explains symbols associated with the remote control box operations and indicators.
Lists essential preliminary checks to ensure the outboard motor is ready for use.
Instructions on preparing the correct fuel mixture for the outboard motor.
Details on how to properly connect the fuel tank and hoses to the motor.
Guidance on how to accelerate the engine while in neutral gear using the control box.
Essential checks to perform before attempting to start the outboard motor.
Step-by-step instructions for starting the outboard motor when it is cold.
Checks to perform immediately after the motor has started to ensure proper operation.
Defines the operator's responsibilities for safe navigation and passenger safety.
Instructions on how to tilt the outboard motor up and down.
Steps for starting the motor using an emergency cable with manual start.
Steps for starting the motor using an emergency cable with electric start.
Methods for immediately stopping the motor in an emergency situation.
Standard procedures for stopping the outboard motor under normal operating conditions.
Instructions for cleaning the painted exterior parts of the outboard motor.
Guidance on cleaning the cooling water passages to maintain performance.
Detailed steps for changing the gearbox oil in the outboard motor.
Guidance on inspecting, cleaning, and replacing spark plugs for optimal performance.
Explains the purpose and maintenance of the sacrificial anode for corrosion protection.
Step-by-step instructions for safely removing and installing a new propeller.
Guidelines for safely storing the fuel tank for extended periods.
Recommendations for storing the battery to maintain its condition.
General