IMPORTANT HANDLING INFORMATION
Read the following information before using the SENAPTEC STROBE. This page contains critical and essential information relating to
use of the Senaptec Strobe, its corresponding warranty, and Senaptec’s liability for any damages relating to the Senaptec Strobe.
NOTICE: Failure to follow these handling instructions could damage SENAPTEC STROBE and void any warranty or return policy
oered by Senaptec.
Always store SENAPTEC STROBE in the hard case provided when not in use.
SENAPTEC STROBE should be stored and used within acceptable temperatures 32-122°F (0-50°C), Do not leave SENAPTEC STROBE
in your car as temperature may exceed 122°F (50°C).
Clean the SENAPTEC STROBE lens using the micro-ber cleaning cloth or other soft cloth. Be sure cleaning cloth is clean and free of
any lint or debris. Wipe lens lightly to remove any dirt or smudges. Do not use cleaning products on lens.
SENAPTEC STR0BE must be disposed of properly according to local laws and regulations.
ONE YEAR LIMITED WARRANTY
Your Senaptec product is warranted to be free of defects in materials or workmanship, under normal use, for a period of one year
from the date of purchase. This limited warranty excludes damage resulting from improper care or handling, accidents,
modication, unauthorized repairs, normal wear, or other causes which are not defects in materials and workmanship, lf your
product is defective, return it and the store receipt to the place of purchase. lf there is a covered defect, Senaptec will replace the
product (subject to availability) or issue a refund. We reserve the right to refuse either replacement or refund (but not both) if the
cost of doing so would be disproportionate to the defect.
THE ABOVE-DISCUSSED LIMITED WARRANTY IS IN PLACE OF ALL OTHER EXPRESS AND IMPLIED WARRANTIES OF ANY KIND, WHICH
ARE HEREBY EXPRESSLY DISCLAIMED AND RENDERED OF NO FORCE AND EFFECT INCLUDING, BUT NOT LIMITED TO THE IMPLIED
WARRANTY OF MERCHANTABILITY, NON-INFRINGEMENT AND FITNESS FOR ANY PARTICULAR PURPOSE. SENAPTEC’S SOLE
OBLIGATION AND LIABILITY FOR PRODUCT DEFECTS SHALL BE, AT SENAPTEC’S OPTION, TO REPLACE SUCH DEFECTIVE PRODUCT
OR REFUD TO BEERY THE AMOUNT PAID BY BUYER THEREFORE.
IN NO EVENT SHALL SENAPTEC BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, PUNITIVE, EXMPLARY, OR CONSEQUENTIAL
DAMAGES ARISING OUT OF OR RELATING TO ANY SENAPTEC PRODUCT OR SERVICE, INCLUDING WITHOUT LIMITATION ANY AND
ALL LIABILITY FOR LOST PROFITS, LOST SAVINGS, OR LOSS OF BUSINESS OPPORTUNITY. BUYER AND/OR USER EXPRESSLY AGREE
THAT ANY RECOVERY IS LIMITED TO THE PURCHASE PRICE. IN NO EVENT SHALL SENAPTEC’S LIABILITY EXCEED THE BUYER’S
PURCHASE PRICE FOR THE SENAPTEC STROBE. No other person or company is authorized to change this limited warranty, and your
dealer is solely responsible for any other warranties.
The foregoing is without prejudice to other legal rights that may arise under applicable national legislation.
The Senaptec warranty extends only to products purchased from an authorized Senaptec distributor. The warranty does not apply
to consumable parts, such as batteries unless damage had occurred due to defect in materials or workmanship.
If you do not accept any of the foregoing information, do not use the SENAPTEC STROBE. If you have any questions regarding the
foregoing information please contact Senaptec at: support@senaptec.com.
To Next Page
Loading...