Sencor SCG 3050SS - Page 6

Electric Coffee Grinder
SCG 305055
BEFORE FIRST USE
1. Remove the coffee grinder from the packing material.
2. Remove the lid AQ by turning it anticlockwise. Wash the lid AQ) under running water using kitchen
detergent. Then rinse it under running water and dry thoroughly. Wipe the hopper AG) and the
grinding blade A® with a lightly dampened wiping cloth and then wipe it until it is thoroughly dry.
Attention:
When cleaning the grinding blade AG), be very careful not to injure yourself with it.
USING THE COFFEE GRINDER
1. Wind the power cord out of the storage area A®.
Remove the lid AO by turning it anticlockwise. Pour coffee beans into the hopper AQ). The
maximum capacity of the hopper A® is 60 g. Do not fill it up above the edge.
3. Place the lid AO) on to the hopper AG) and turn it clockwise until you hear an audible click. Now
the lid AO is locked in place and will not come off by itself.
4. Connect the coffee grinder to an el. power socket and press the pulse button AG) to start the coffee
grinder. The coffee grinder will continue to run while the button AG) is pressed. The coarseness of
the ground coffee can be regulated by the grinding time. The longer you grind it, the finer it will be.
A Attention:
The coffee grinder is equipped with a safety feature that prevents its operation if the lid is not
correctly attached.
The maximum continuous operating time is 30 seconds. After 30 seconds of continuous operation
allow the coffee grinder to rest for 2 minutes.
Ve’ Tip:
Always prepare your coffee beverage from freshly ground coffee. Coffee that is ground in
advance loses its flavour and aroma.
AM
5. To end the operation, release the pulse button AG). Disconnect the coffee grinder from the el.
power socket. Turn the lid A@ anticlockwise to release it, then take it off. Tip the ground coffee
into a suitable container.
If you wish to grind another batch of coffee, repeat the above procedure.
7. Always disconnect the coffee grinder from the el. power socket after finishing using it and clean it
out according to the instructions contained in the chapter Cleaning and maintenance.
cd
CLEANING AND MAINTENANCE
e Before cleaning the appliance, disconnect it from the power socket.
e Clean the lid AG) using warm water with kitchen detergent after every use. Then rinse it with clean
water and dry thoroughly with a fine wiping cloth.
e Clean the remaining ground coffee out of the hopper AG) and off the grinding blade AG). Then
wipe with a dampened wiping cloth and then thoroughly wipe it out until dry.
Attention:
When cleaning the grinding blade AG), be very careful not to injure yourself with it.
Copyright © 2013, Fast CR, a.s. Revision 07/2013