Sencor SHP 90 - Maintenance and Care; Body Cleaning; Cutting Head Cleaning and Lubrication

Hair clipper
SHP 90
-©- Tip:
“'* We recommend not to initially cut your hair or beard too short.
CLEANING AND MAINTENANCE
It is best to clean the cutting unit and the comb attachments after each cutting, so
as to avoid its excessive fouling with hair and whiskers.
Cleaning the body of the clipper:
You can clean the body of the hair clipper using a lukewarm moist cloth. Do not
use harsh cleaning fluids, paint thinners or solvents. These can damage the surface
of the appliance.
Caution:
ei Do not submerge the body of the hair clipper under water because it contains
parts under live current (recharging battery)!
Cleaning of the cutting head:
1) Turn off the clipper and if the power adapter is connected remove it from the
power outlet and from the clipper.
2) Remove the comb attachment from the device. Using your thumb push the
cutting unit back and pull it out.
3) Using the cleaning brush supplied, remove the remaining hairs from the cutting
head.
4) After the cutting unit is fully cleaned, insert it back into the device by placing
the bottom lug on the cutting head into the bottom opening in the upper part
of the hair clipper body, then firmly press on the cutting head until you hear
a click.
Lubricating the head:
1) Remove the comb attachment from the device. Using your thumb push the
cutting unit back and pull it out.
2) Place one or two drops of the supplied oil in between the cutting blades and
spread it evenly. After using up the supplied oil use only oil not containing acids
(e.g. oil for sewing machines).
3) Wipe off excess oil using a cloth.
4) Then insert the cutting head back into the device by placing the bottom lug
on the cutting head into the bottom opening in the upper part of the hair
clipper body, then firmly press on the cutting head until you hear a click.
Copyright © 2012, Fast CR, a.s. Revision 06/2012