Sencor SPT 300 - Page 4

Power Connection
Connecting AC Power
Connect the small end of AC cord to the socket at the back of the main unit and insert the plug of AC
cord into standard AC wall outlet.
Caution:
The unit is designed to operate from mains supply of AC 230V~50Hz. If the plug of AC cord does
not fit properly, try to turn it over and try again. Do not force it.
When the unit is intended for being unused for a long period of the time. Please press the POWER
button up to OFF position to turn off the unit and unplug the power cord from the AC wall outlet.
..
(e)
\
АС Outlet
== == >= —.
oo
De,
=>
==> == ==> >. =>
== == === one
%%
(AI
Battery Operation
Before installing batteries (not included), ensure that the unit is disconnected from the mains supply.
Remove the battery compartment cover on the bottom of the unit by lifting up the two lugs on the
battery cover. The battery cover can then be lifted up.
Install 8 pieces of 1.5V (UM1) batteries (not included) by following the polarity markings and then
replace the cover.
For battery operation, unplug the AC cord from the AC wall outlet first and then remove the AC cord
from the socket at the back of the main unit.
Caution:
There is a danger of explosion if batteries are replaced incorrectly.
Replace batteries with the same type and same brand only.
When the unit is intended for being unused for a long period of the time. Press the POWER button
up to OFF position and remove all batteries from the main unit.
EE!
М
р иы
1.5VXBIDEIZVOLTI
EN-3