EN – 5
Automatic scan
1. Press and hold the TUNING / button until the frequency on
the display starts to change.
2. When a station with a strong enough signal is found, tuning stops.
Alternatively, you can stop the automatic tuning by pressing the
TUNING / button again-
Pre-settings
You can store the frequencies of up to 50 radio stations in the memory
(50 stations in the FM band). You can erase a stored frequency from
the memory by storing other frequency in its position.
Automatic saving to preset
1. Press and hold the PROG button until the frequency changes on
the display.
Manual saving to preset
1. Tune into the desired station (see Tuning).
2. Press the PROG button once to activate the programming mode.
3. Press / select the desired memory location.
4. Press the PROG button again to confi rm the selected station.
5. Listening to a preset station:
• Press the / button to select the desired station.
Improved reception:
- To receive in the FM band, extend the telescopic antenna. To
improve reception in the FM band, tilt and rotate the antenna; if
the FM signal is too strong (you are very close to the transmitter),
shorten its length.
PLAYBACK FROM USB AND MICRO SD CARD
The unit supports playback of MP3 fi les stored on storage media
connected via the USB connector or memory card slot.
1. Press MODE to select USB or SD.
2. Before connecting a USB device to the device, make sure that the
connector is turned correctly and connect it. Or insert the memory
card with the contacts to the back of the device. The memory
To Next Page
Loading...