Sengoku OR-77 - Replacement Instructions Manual

1
Step 6
Unscrew the screw which holds the wind
cover and take off the wind cover.
Step 5
Unscrew 4 wing nuts.
Step 4
Carefully lift off the case.
Step 3
Unscrew 4 screws from the each side of
the case.
Step 2
Remove the wick adjusting knob by pull-
ing straight out. Remove the tank cap.
Step 1
Remove the batteries from the heater.
These Instructions are for the following models: OR-77 and OR-78.
Wick replacement should be performed on a completely cool heater after the tank is empty
and the remainder of the kerosene in the heater has been burned off.
Wick Replacement Instructions for Omni Radiant Kerosene Heaters