16
17
Programme selector
1. When the LED display screen
brightens up, rotate the programme control to select the desired
programme.
2.Select the【Delay】or【Anti-Crease】functions for additional
option.
3.Press the【Start/Pause】key.
Press the 【On/Off】button.
Programme start
Programme end
1.The drum will stop running after the programme ends, the
working state LED will stay light and buzzer will ring.The “Filter”
and”Full”LED will remind user to clean the filters and container.
The dryer will start Anti-crease function if user doesn’t
remove the load in time (refer to page 15). Press
key to cut off the mains power and pull the plug out.
2.Deal with any problems according to the “Malfunction display
and solutions , if there is an unexpected stop during the
drying procedure and the dryer shows information (refer to page 18 ).
【 】
【On/Off】
”section
The drum will keep rotating after the programme starts, the state
light in the display area will flash in sequence, the remaining time
displayed will change automatically.
Instructions of the 【Delay】function
This function is used for delaying clothes drying time within 24
hours. The delay time means the programme will start after x hours.
When the delay programme starts, the time starts to decrease on
the display and the delay icon blinks.Steps in details:
1.Load your laundry and make sure the machine door is closed.
2.Press the 【On/Off】button,then to turn the programme selector
control and select your desired programme.
3.You can select the 【Anti-Crease】functions according to your need.
4.To delay, press the【Delay】 key.
5.Continue to press the 【Delay】to select the delay time.
Instructions of the Anti-Crease function【 】
At the end of the drying cycle,the anti-crease phase time is 30
minutes (default ) or 120 minutes (selected).
This function prevents the laundry from creases. The laundry can
be removed during the anti-crease phase. Except 【Cool】,
【Refresh】, all the other programmes have this function.
Instructions of the Child Lock function【 】
1.This machine incorporates a special child safety lock, which can
prevent children from carelessly pressing keys or making a
faulty operation.
2.When the dryer is in the operation state, press the【Anti-Crease】
and 【Signal】buttons at the same time for over 3 seconds to
start child lock function. When child lock function is set, the
display will show Child lock icon and no key can effect the dryer
except 【On/ Off】button. Under the start state of the child lock,
the【Anti-Crease】and 【Signal】buttons should be pressed at the
same time for over 3 seconds to release the child lock function.
6.After the 【Start/Pause】 key is pushed, the Dryer is in the run
condition. The drying procedure will be automatically performed
when the delay time is over.
7.If you push the【Start/Pause】button again, the delay function
will be paused.
8.If you want to cancel the “Delay” function, press the 【On/Off】
button.
Other Functions
To Next Page
Loading...