19
14. MEMORY FUNCTION
Press" 0/MEMORY" to choose memory 1-3 procedure. The LED will display 1, 2, 3.
If the procedure has been set, press "START/+30SEC." to use it. If not, continue to
set the procedure. Only one or two stages can be set.
After nishing the setting, press "START/+30SEC." Press once to save the procedure
and turn back to the standby mode. If press " START/+30SEC. " again, it will start
cooking.
1)
2)
3)
Example:
To set the following procedure as the second memory, that is memory 2. To cook the
food with 80% microwave power for 3 minutes and 20 seconds.The steps are as
In standby mode, press"0/Memory" twice,the screen displays "2".
Press "TIME COOK" once,then press "3","2","0" in order.
Press "POWER" once,"PL10" display, then press "8" and "PL8" displays.
Press "START/+30SEC." to save the setting. If you want to run the saved procedure,
in standby mode, press "0/Memory" twice, screen displays "2", then press
"START/+30SEC. " to run.
a.
b.
c.
d.
Note:
If the electricity is not cut o, the procedure will be saved all the time. If it does
the procedure need to be reset.
15. MULTI-STAGE COOKING
At most 2 stages can be set for cooking. In multi-stage cooking, if one stage is defrost-
ing, then the defrosting shall be placed at the rst stage automatically.
NOTE: Auto cooking can’t work in the multi-stage cooking.
Example:
If you want to cook with 80% microwave power for 5 minutes + 60% microwave
power for 10 minutes. The cooking steps are as following:
Press "TIME COOK" once, then press "5","0","0" to set the cooking time;
Press "POWER" once, then press "8" to select 80% microwave power.
Press "TIME COOK" once, then press "1","0","0","0" to set the cooking time;
Press "POWER" once, then press "6" to select 60% microwave power.
Press "START/+30SEC." to start cooking.
1)
2)
3)
4)
5)
To Next Page
Loading...