Broadcast calls cannot be made from a radio which is in DMO. Attempting to make a Smart Call in
DMO initiates a group call to the attached talkgroup.
It is not possible to make a Smart Call from a SRG3900/SCG22 radio operating in Gateway Mode
and the Speech Call Settings option is not displayed.
Make a Smart Call
1. Open the Smart Call menu either of the following:
Press a preconfigured soft key.
Use the Speech Call Settings menu (see Speech call settings below.
2. Select mode Smart Call A or Smart Call B.
Your radio goes into Smart Call Mode. The tri-colour LED flashes amber and the active Smart
Call folder is displayed.
3. Select the required talkgroup in the current Smart Group Folder by .
4. Use the PTT (or press the Select context key or the Select/Send key) to transmit to the
chosen talkgroup.
To leave Smart Call Mode
1. Open the Smart Call menu either of the following:
Press a preconfigured soft key.
Use the Speech Call Settings menu (see Speech call settings below.
2.
Select Group or Individual:
Group—returns you to your previous talkgroup
Individual—allow you to make an individual call by dialling
Speech call settings
The Speech Call Settings option is not available if your radio is operating in Gateway Mode.
The Speech Call Settings option is not available if your radio is in Transmit Inhibit on page69.
1. Select Menu > Groups > Speech Call Settings.
2. Select one of the options.
Modifying your call setup
Under certain circumstances, the type of a call which is being initiated by your radio may be modified
by the network or by the recipient of the call. For example, you might make a group call, but the actual
call being established might be converted to an individual call to a dispatcher.
User Guide 55
To Next Page
Loading...