Need help?Do you have a question about the Sequential Drumtraks 400 and is the answer not in the manual?
General| Type | Drum Machine |
|---|---|
| Synthesis | Analog |
| Memory | RAM |
| Outputs | Headphone |
| Power Supply | AC adapter |
| Dimensions | 3.5 inches |
Connect the Drumtraks to a monitor or headphones and power it on.
Adjust the volume level for individual instruments.
How to apply accents to instrument key presses.
Adjust the tuning for individual instruments.
How to start, stop, and loop patterns on the Drumtraks.
How to choose and switch between different patterns.
How to set up patterns to start automatically after the current one.
Adjusting the tempo for pattern playback.
Adjusting the swing timing for patterns.
Using a footswitch for pattern playback control.
Using a footswitch for pattern selection and song control.
How to clear existing patterns before recording new ones.
Step-by-step guide to recording a new drum pattern.
Setting the numerator and denominator for pattern time signatures.
Setting the length of a pattern in measures.
Programming individual instrument volumes within a pattern.
Programming individual instrument tuning within a pattern.
Using error correction for timing and erasing instrument parts from patterns.
Overdubbing notes with different volume or tuning settings.
Duplicating an existing pattern to a new location.
Adding one pattern to the end of another.
Monitoring and managing pattern and song memory usage.
How to clear existing songs before recording new ones.
Step-by-step guide to constructing songs from patterns.
Controlling song playback using the RUN/STOP switch.
Cueing the next song or stopping a song at its end.
How tempo affects song playback.
Using a footswitch to control song playback.
Using a footswitch to repeat patterns within a song.
Duplicating an existing song to a new location.
Adding one song to the end of another.
Modifying existing song steps and pattern selections.
Adding new steps into an existing song sequence.
Removing steps from an existing song sequence.
Adding steps to the end of a song.
Programming volume adjustments for specific song sections.
Setting the starting tempo for a song.
Programming tempo changes relative to the song's starting tempo.
How to properly end songs and exit the build mode.
How to connect a cassette recorder to the Drumtraks.
Steps for saving patterns and songs to cassette tape.
How to verify that saved cassette data is correct.
Troubleshooting steps when cassette saving fails verification.
Steps for loading patterns and songs from cassette tape.
Troubleshooting steps when cassette loading fails.
Receiving external clock signals for synchronization.
Sending clock signals to external sequencers or synthesizers.
Using the Drumtraks clock out with a sequencer.
Synchronizing the Drumtraks with a multi-track tape recorder.
How to connect the Drumtraks to MIDI instruments.
Controlling Drumtraks instruments with an external keyboard.
Interconnecting two Drumtraks units for master/slave operation.
Connecting the Drumtraks to sequencers and managing MIDI settings.
To Next Page