The fuse is used to protect the electrical components and
circuits in the vehicle to avoid short circuit or overload. If
the fuse is blown, the protected components and systems
will not work normally.
1. Locate the fuse box or instrument fuse box in
the range extender compartment.
2. Press the plastic sheet on either side and
remove the fuse box cover.
3. Pull out the fuse and check whether the bent
wire is blown.
4. If it is blown, replace it with a new fuse of the
same amperage.
Protect the fuse box from contamination and
moisture, or it may damage electrical components
or systems.
Do not remove or replace any relay, If any insurance wire
and relay failure, Please contact SERES center.
• always manually cut off the power supply of the
vehicle before replacing the fuse.
• the battery will produce explosive and flammable gas,
so open fire or electric spark is prohibited near it,
otherwise it may cause explosion.
• when replacing, only substitute fuses approved by
SERES vehicle with the same grade and specification
can be used. If the fuse is not selected properly, it will
damage the electrical system and cause fire.
• if the replacement fuse blows after installation, please
contact SERES after sales service center to check the
electrical system.
Illustration: left position of front compartment
All fuses should be operated by SERES.
Illustration: under the driver's side of the instrument
panel
To Next Page
Loading...