Motor surface cleaning and
connector
Power assembly mounting
bracket and mounting bolt
Connecting bolts between power
assembly mounting bracket and
motor
Motor controller surface cleaning
and connector
Butt bolt of motor and reducer
Reducer surface cleaning and
connector
Water inlet and outlet pipes of
motor and controller
Reducer lubricating oil (atf-vi)
①
Check during each maintenance and replace it every 5 years or every 100000 km,
whichever comes first (front drive motor assembly)
Reducer lubricating oil (Castrol)
805C）
Check during each maintenance and replace it every 5 years or every 100000 km,
whichever comes first (rear drive motor assembly)
Replace it every 4 years or every 100000 km, whichever comes first
I―check these items and their related parts, and correct, clean, supplement, adjust or replace
them if necessary; R - replace or change.
① Follow the "recommended oil / grease specification and capacity table" in this chapter.
② If necessary, transpose or balance the wheels.
• During the use of the vehicle, if the vehicle environment or operating conditions are relatively bad (long-term
load-bearing, unsatisfactory air quality, high temperature, mountainous roads and other environments), the
maintenance frequency can be increased in time according to the requirements of the maintenance cycle table.
interval
(
months）
12
24
36
48
60
72
84
96
108
120
132
144
156
168
180
item
（x1000km）
10 20 30 40 50 60 70 80 90
100 110 120 130 140 150
high voltage harness assembly
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
To Next Page
Loading...