Need help?Do you have a question about the Serial Cables PCI-AD-x16HE-BG4 and is the answer not in the manual?
Explains the function of LED7 as a heartbeat indicator for the Atlas switch's operational status.
Details LED6's role in signaling any detected failure conditions within the Atlas switch.
Describes LEDs 2-5 indicating port link status and device connection types.
Command to update configuration files or firmware for the Atlas PCIe switch.
Command to display environmental information like temperature, fan speed, and voltages.
Command to write 32-bit data to device registers for low-level access.
Command to dump switch-specific register values for diagnostic purposes.
Command to dump switch port-specific register values.
Command to dump the contents of the switch-specific flash memory.
Command to issue the PERST# signal to specific ports or all ports on the device.
Command to display link speed and width information for all ports.
Command to scan for I2C devices connected to the Atlas host card.
Command to show or set the SSC frequency for the Atlas switch.
Command to control the clock output status for downstream ports.
Command to write data to a device via I2C interface.
Command to write data to a device via I2C interface, supporting SC and AC modes.
Command to display card information, uP FW, and Atlas FW versions.
Command to reset the microcontroller firmware (uP FW) on the host adapter.
General| Brand | Serial Cables |
|---|---|
| Model | PCI-AD-x16HE-BG4 |
| Category | Computer Hardware |
| Language | English |
To Next Page