Sertain S4540 - CLEANING & MAINTENANCE; General Maintenance Checks; Electrics Maintenance

To Next Page

To Previous Page

DO NOT USE CHAIR UNTIL YOU HAVE FULLY READ THE INSTRUCTIONS

7. CLEANING & MAINTENANCE

GENERAL MAINTENANCE

The following should be checked and adjusted if required, at a minimum of two monthly intervals:

» All nuts and bolts on pivot points:

• If they are loose, tighten without restricting pivot operation.

• If they are worn, replace with a Careleda approved fastener.

» All functions of chair – i.e. backrest, seat tilt, leg rest, footrest, wings and arms, directional lock,

braking system – refer to supplier for any repairs required

» Upholstery inspection – any tears, rips, parts missing, etc – refer to supplier of chair for

replacement parts

» Castors

• Check condition and ensure they are freewheeling and bearings are not loose.

• Remove any grime and grime build-up.

• Check that directional lock and brake functions both work correctly.

• Please note: All pintles must be checked at regular intervals. They must be fully and rmly

tted in tube and locating device. Retaining screw must be tight. All faulty parts must be

replaced immediately.

• Electrics

• All cables and motors to be inspected for damage.

ELECTRICS – MAINTENANCE

» Valid for all LINAK products

» The LINAK products must be cleaned at regular intervals to remove dust and dirt and inspected

for mechanical damage, wear and breaks.

» The LINAK products are closed units and require no internal maintenance.

» Only type IP66 are waterproof and type IP66W tolerates being washed in tunnels.

» This chair and its LINAK components are not rated IP66 washable.

7 Trouble

Shooting Procedures 30-39