Need help?Do you have a question about the Servore SERVO GLAS 5000X Autolift and is the answer not in the manual?
General| Viewing Area | 100 x 60 mm |
|---|---|
| Arc Sensor | 4 |
| Shade Control | External, Variable |
| Sensitivity Control | Adjustable |
| Grinding Function | Yes |
| Operating Temperature | -5°C to +55°C |
| Storing Temperature | -20°C to +70°C |
| Power On/Off | Automatic |
| UV/IR Protection | Up to shade DIN 16 |
| Power Supply | Solar Cell |
| Helmet Material | Polyamide |
Guide on how to adjust the shade level for different welding processes and current levels.
Instructions for adjusting the light sensitivity to optimize performance in various welding conditions.
Explains how to adjust the delay time for the filter to clear after welding.
Information on the RF sensor switch for controlling sensitivity in different RF environments.
Step-by-step instructions for replacing the front and rear cover plates of the helmet.
Detailed guide on how to replace the batteries in the welding helmet.
Instructions for removing and installing the inner cover plate on the welding helmet.
Procedure for assembling and disassembling the Auto Lift mechanism for proper maintenance.
To Next Page