EasyManua.ls Logo

SEVERIN BA 3234 - Ironing Features and Operation; Foldable Handle Usage; Steam Selector and Filling; Ironing Symbol Guide

SEVERIN BA 3234
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
When operating the steam iron, hold only
by the handle.
The iron should only be placed on
heat-resistant surfaces, never near hot
surfaces (eg hot-plates) or in the vicinity
of open gas ames.
Do not allow the power cord to touch
hot surfaces. Do not coil the power cord
round the appliance.
Always remove the plug from the wall
socket
- after use,
- in case of any malfunction,
- before cleaning the appliance.
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
This appliance is intended for domestic or
similar applications, such as
- in shops, of ces and other similar
working environments,
- in agricultural working environments,
- by customers in hotels, motels etc. and
similar establishments,
- in bed-and breakfast type environments.
Foldable handle
Before the iron is used, press the handle
release and fold the handle upwards
until it locks securely into the operating
position.
After use, the handle can be folded
down again for space-saving storage by
pressing the release button.
Steam selector switch
With the steam function activated, an
additional hot steam jet is emitted from
the soleplate.
In order to use the steam function, the
temperature control must be set to the
steam-section marked on the control
knob.
Filling with water
Fill the water reservoir before using the
steam function. Remove the plug from
the wall socket before lling the reservoir.
We recommend using decalci ed water to
prevent the build-up of lime deposits.
Press the handle release and lock the
handle in the operating position.
Turn the steam selector to the ‘
position.
Open the rubber lid on the water reservoir
by lifting up the side with the symbol ‘ ’;
do not lift up the opposite side.
Fill the empty water reservoir using
the measuring cup provided. Fill to the
indicated “Max” level only.
Close the water ll hole.
General information about ironing
Always check rst whether a label with
ironing instructions is attached to the
article to be ironed.
The meaning of the ironing symbols is as
follows:
• synthetics
(low temperature)
•• silk and wool
(medium temperature)
••• cotton and linen
(high temperature)
These markings can also be found on the
temperature control knob of the steam

Related product manuals