EasyManua.ls Logo

SEVERIN EZ 7404 - Appliance Operation and Preparation; Appliance Applications; Before First Use; Ice-Cream Bowl Preparation

SEVERIN EZ 7404
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
Do not let the power cord hang free.
Do not allow the appliance or its power
cord to touch hot surfaces or to come into
contact with any heat sources.
No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
Applications
The appliance is suitable for making
ice-cream, fruit ice-cream (sorbet), frozen
yoghurt or chilled drinks.
Before using for the rst time
Remove any packing materials
completely.
Clean the appliance as described in the
section Cleaning and care.
Operation
Ice-cream bowl
To make ice-cream, the ice-cream bowl
must be chilled at a minimum of -18°C for
at least 8 hours.
When handling the bowl, ensure that your
hands are dry or use suitable gloves.
Verify that the ice-cream bowl is
thoroughly chilled, by shaking it if
no liquid appears to move inside, the
required degree of chilling has been
reached.
Hint:
To prevent the contents of the bowl from
melting, the bowl should only be taken
from the freezer shortly before use.
If the bowl is kept permanently in a
freezer, you will be able to make ice-
cream at any time.
Preparation
Cool the ice-cream bowl for approx. 8
hours (see section Ice-cream bowl).
Prepare all ingredients according to the
chosen recipe. The maximum ll capacity
is 1 litre.
Place the chilled ice-cream bowl into the
housing.
Place the drive unit into the lid and t the
stirring insert into the drive mechanism on
the drive unit.
Place the lid and drive unit onto the
housing and push the assembly down
lightly until it is heard locking into place.
Insert the plug into a suitable wall outlet.
Use the On/Off switch to turn the unit
on. The bowl starts rotating. Feed the
ingredients slowly through the chute into
the bowl.
Depending on the temperature of the
ice bowl and the ingredients, the desired
consistency of the ice-cream should be
achieved after 20 to 40 minutes.
After a certain time, the motor reverses
direction. Such changes of direction
becoming frequent at short intervals
indicates that the ice-cream has reached
a rm consistency, and at this point the
appliance should be switched off without
delay.
Remove the plug from the wall outlet.
Push the lid release and remove the lid
and drive unit from the housing.
Use a plastic spatula or other suitable
implement to remove the ice-cream.
Caution: Do not use any metal
objects.
If you prefer a rmer consistency, transfer
the ice-cream into an air-tight container
and place it in a freezer until the desired
consistency is reached.

Related product manuals