SEVERIN HM 3843 - Battery Charging and LED Indication; Appliance Operation and Ejection

16
104 x 142 mm
Charging the Battery
∙ Charge the battery regularly, especially
after any long period without use. This
extends battery life and ensures the
longest possible processing cycles.
∙ During the charging process, the
appliance cannot be used.
∙ Plug the power adapter of the included
power supply unit into the socket on the
handle.
∙ Connect the power adapter supplied to
the power socket.
∙ The LEDs should start to ash.
∙ When the battery is fully charged, all
LEDs light up permanently. When the
battery is empty, the charging process
takes approximately 2 hours.
∙ Unplug the power supply unit from the
power socket.
∙ Take the power adapter of the power
supply unit out of the connection socket
for the appliance.
LED indication
The six LEDs on the handle indicate the
battery charge level:
Charging:
∙ When the battery is low, the rear LEDs
ash; when the battery is medium, the
middle LEDs ash; and when the battery
is high, the front LEDs ash.
∙ The more LEDs that are permanently lit,
the higher the charge level.
∙ When all LEDs light up permanently, the
battery is fully charged.
Operation:
∙ The fewer LEDs that are lit, the lower
the charge level.
∙ When the battery power is below 20%,
the rear two LEDs appear ashing.
Overload:
∙ If all LEDs ash simultaneously, the
appliance is overloaded and switches
off. You can switch it again immediately.
If necessary, add less dough to prevent
the appliance from switching off again.
Operation
∙ Insert the selected attachments into
the openings on the underside of the
blender and push them gently upwards
until they lock into place.
∙ Depending on the quantity of
ingredients, use a sufciently deep bowl.
∙ Any bowl, round container or glass is
suitable, provided it is scratch-proof and
the attachments can rotate freely inside.
∙ Once the attachments are tted, take
the blender in hand and position the
attachments inside the container lled
with the ingredients.
∙ Use the switch to turn the appliance on.
∙ Once processing is nished, or if you
wish to interrupt the operation, switch off
rst and wait until the motor has come
to a complete standstill before lifting the
attachments out of the mixture.
Ejecting the attachments
∙ Always switch off the appliance from
before any attachments are ejected.
∙ The attachments are automatically
detached ( ) when the release button
is pressed.