SEVERIN KM 3864 - Page 13

104 x 142 mm
13
∙ Place the cutting&shredding attachment
onto the bowl and turn clockwise to lock.
The dispenser chute is on the left side of
the appliance.
∙ Place a suitable container under the
dispenser chute.
∙ Insert the plug into the wall outlet and
use the rotary control to select the
required power setting.
∙ Load the food into the feeder chute
and insert the pestle. Guide the pestle
slowly downwards, without applying rm
pressure. Do not put your ngers into
the chute.
∙ The processed food is collected inside
the container.
∙ Remove the pestle and, if required, add
more food.
∙ After use, turn the appliance off and
disconnect it from the mains.
∙ Unlock and take off the individual
components.
Herbs, onions, meat, etc. must be
chopped
∙ See g. II.
∙ Place the bowl onto the drive unit and
turn clockwise to lock, so that the two
triangular symbols are aligned.
∙ Fit the smaller blade unit on the larger
one and turn anti-clockwise ( → ),
until it is heard locking into place.
∙ Fit the cutting blade unit onto the drive
shaft.
∙ Chop the food roughly and load it,
observing the ‘Max’ ll level.
∙ CAUTION: The blades are very sharp.
When handling the blades, always hold
them by their upper protective plastic
covering.
∙ Place the lid on the processing bowl and
turn it clockwise until it locks into place.
∙ Insert the plug into the wall outlet and
use the rotary control to select the
required power setting.; process the
food until it has reached the required
consistency.
Hint: Chopping food usually takes
only a few seconds. We recommend
setting the rotary control to P and
processing the food in brief bursts.
∙ After processing, always switch off
and remove the plug from the wall
socket rst before removing the lid.
Carefully remove the blade unit and the
processed food, then unlock and detach
the bowl.
∙ When processing further food after the
rst cycle, make sure that the drive shaft
at the bottom of the bowl is free of food
residue before retting the blade unit.
Emulsifying / blending - Cream, egg
white, mayonnaise
∙ See g. III.
∙ Place the bowl onto the drive unit and
turn clockwise to lock, so that the two
triangular symbols are aligned.
∙ Fit the emulsifying disk onto the drive
shaft.
∙ Put the ingredients into the bowl.
Fill quantities:
Cream: max. 170 ml
Egg white: max. 3 eggs
Mayonnaise: up to the Max marking
∙ Place the lid on the processing bowl and
turn it clockwise until it locks into place.