attachments,
- after use,
- in case of any malfunction, and
- during cleaning.
● When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
● Children are not aware of the dangers
that may occur when operating electrical
appliances. Therefore keep such
appliances away from children.
● No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
● This appliance is intended for domestic
use only and is not designed for medical
or commercial applications.
● In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The addresses can be found in the
appendix to this manual.
Before using for the first time
Remove the appliance from its packaging
and ensure that any packaging materials are
completely cleared away.
Wall mounting
The appliance can be wall-mounted or
placed on the floor. For wall mounting,
proceed as follows:
-
We recommend mounting the appliance
at a minimum distance of 1 m from the
bath itself. To prevent the possibility of
anyone using the bath coming into
contact with the main unit, it should be
mounted at a minimum height of 1.8 m.
Ensure at all times that the appliance is
placed in such a way that it cannot
accidentally fall into the bath, sink or
toilet bowl.
-
The appliance must be connected to a
wall socket located well outside the safety
limits shown in diagram I.
-
The template provided will help to mark
the correct distance between the holes to
be drilled on the wall.
-
Drill two 7 mm holes to a depth of 28
mm. Before drilling, ensure that the wall
section chosen is free of any internal
pipes, electrical cables etc.
-
Push the plugs provided fully into the
drilled holes. Insert the screws leaving
approx. 7 mm protruding.
-
Position the keyhole openings on the
appliance (hose connection facing down)
over the screw heads and push it slightly
down. If necessary, the screws may have
to be adjusted for positive mounting.
Remote control
The water-proof remote control has 3
function buttons. To ensure best results, it
should be pointed towards the appliance.
The On/off button switches the
appliance on and off.
This button serves to adjust the bubble
intensity.
The timer button is used for activating
the timer and adjusting its settings.
Display / Indicator lights
The display features three areas with
indicator lights.
The indicator lights on the left show the
currently selected bubble intensity.
The light in the middle section is the
main indicator light.
The indicator lights on the right show
the current timer setting.
Timer
The timer allows you to set the time after
which the appliance automatically switches
off. 15, 30 or 60 minutes can be selected.
6
To Next Page
Loading...