10
damage results from improper use, or if
these instructions are not complied with.
∙ This appliance is intended for domestic or
similar applications, such as
- in shops, offi ces and other similar
working environments,
- in agricultural areas,
- by customers in hotels, motels etc. and
similar establishments,
- in bed-and breakfast type environments.
Switch positions
The appliance is equipped with a 3-position
switch allowing for the following settings:
Functions:
0 = Off
1 = Half power
2 = Full power
Operation
Make sure the appliance is used on dry hair
only.
∙ Insert the plug into a wall socket.
∙ Turn the curler on. The indicator light
comes on.
∙ Let the curler heat up for approximately 5
minutes.
∙ Divide the hair into separate strands, grip
the end of a strand with the clamp and
curl it up to the hairline.
∙ The integrated swivel makes it easy to
use the curler in this way.
∙ Hold the hair curled up for a few seconds,
then open the clamp, hold the curl and
remove the curler gently from the hair by
turning it.
∙ Let the hair cool down suffi ciently before
brushing it out.
∙ Switch the appliance off after use. When
the indicator light goes out, remove the
plug from the wall socket.
Round brush attachment
To use the round brush, it must be fi tted
over the clamp in such a way that the
locking catch is securely engaged in the
corresponding socket. To remove the brush,
push the locking catch forward out of its
socket until it locks into place on the axis
of the mounting clip. The brush can now be
pulled off from the clamp.
∙ The round brush is designed for shaping
the hair. To achieve this, the hair should be
divided into single strands (not too thick)
and then spread evenly over the brush,
turning them inwards or outwards as
desired.
∙ Apply for a few seconds at a time only,
while allowing the hot air to take effect on
the hair. Let the strands uncurl afterwards.
∙ Let the hair cool down suffi ciently before
brushing it out.
General cleaning and care
∙ Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
∙ To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
∙ Do not use abrasives or harsh cleaning
solutions.
∙ If necessary, the housing may be wiped
with a dry lint-free cloth.
∙ Remove any loose hair from the round
brush attachment after use.
Disposal
Devices marked with this symbol must be
disposed of separately from your household
waste, as they contain valuable materials
To Next Page
Loading...
