SEVERIN MW 7773 - Clock and Microwave Power Settings

23
142 x 208 mm
Note: The following steps are used for setting the cooking time:
0 – 5 minutes : 10-second steps
5 – 10 minutes : 30-second steps
10 – 30 minutes : 1-minute steps
30 – 95 minutes : 5-minute steps
Cooling-off function:
This microwave oven has an automatic cooling feature.
After any operating time exceeding two minutes, the cooling fan will automatically run for three minutes after the programme
stops. This extends the service life of the appliance, while using very little energy for the fan.
Clock :
Once the unit has been connected to the power supply, the display shows ‘1:00’ and an acoustic signal is heard.
1. Press once or twice to select the 12 or 24 hour display format. The display shows Hr 24 or Hr 12.
2. Turn the rotary control to set the correct hour value.
3. Press . The minute digits are shown.
4. Turn the rotary control to set the correct minutes.
5. Press to nish setting the time. The symbol ‘: ‘ ashes and the correct time is shown.
The time setting process can be cancelled by pressing the key.
The clock must be set when the appliance is connected for the rst time, and also if a power failure has reset the clock.
The microwave function :
To programme the unit for cooking, the correct mode (microwave), the required power setting and the cooking time must be
selected, before the programme sequence can be started. The power setting is selected by repeatedly pressing . The
cooking time can be pre-set to a maximum of 95 minutes.
Power settings
Power (P) Display Type
1 x 800 W P-HI (100 %) High Heating up liquids, cooking
2 x 720 W P-90 (90 %)
3 x 640 W P-80 (80 %)
4 x 560 W P-70 (70 %) Medium high Defrosting and heating up deep-frozen dishes
5 x 480 W P-60 (60 %)
6 x 400 W P-50 (50 %) Medium Cooking delicate food
7 x 320 W P-40 (40 %)
8 x 240 W P-30 (30 %) Defrosting Defrosting food
9 x 160 W P-20 (20 %)
10 x 80 W P-10 (10 %) Defrosting Defrosting sensitive food.
11 x P-00 (00 %) No microwave function, cooling fan only
Example: to programme the microwave function for a cooking time of 5 minutes at 50 % power.
1. Press
6 times. The display shows P- 50.
2. Turn the rotary control until the display shows 5:00.
3. Press the rotary control to start the programme.