SEVERIN MW 7775 - Sequential Program Execution; Setting Multiple Consecutive Programs

27
142 x 208 mm
A-3
Meat
150 g 150
300 g 300
450 g 450
600 g 600
A-4
Bread
50 g 50
100 g 100
150 g 150
A-5
Pizza
200 g 200
300 g 300
400 g 400
A-6
Cake
475 g 475
A-7
Noodles / pasta
50 g (with cold water 450 g) 50
100 g (with cold water 800 g) 100
150 g (with cold water 1200 g) 150
A-8
Chicken/poultry
500 g 500
750 g 750
1000 g 1000
1200 g 1200
A-9
Vegetables
150 g 150
350 g 350
500 g 500
A-10
Potatoes
230 g 1
460 g 2
690 g 3
Setting multiple programmes
The unit may be set for a maximum of 3 programmes running consecutively, e.g. defrosting, followed by microwave and then
hot-air cooking. Any defrosting, microwave, grill or hot-air programmes as well as the combination of the programmes may
be selected. Any defrosting programme must of course run before any cooking programme can be started.
Example: To defrost food before it is cooked, rst with the microwave function and then with the hot-air function.
1. Programme the defrost function (without pressing
)
2. Programme the microwave function (without pressing ).
3. Programme the hot-air function.
4. Press . The display shows the appropriate symbols for the selected programmes.
5 beeps indicate that the entire programme has nished.
Hint: This memory function is especially helpful when using the microwave to cook food at different power settings. While a
higher power setting is selected initially, the power can be reduced at a later stage in order to keep the food hot, and
to ensure that the heat is evenly distributed when the food is already done.