entered.
3. Press . The display shows CODE COOK CONV.
Halfway through the cooking process, a beep indicates that the skewer must be turned.
Open the door, turn the skewer, close the door and press .
Cakes ( )
1. Turn , until the display shows CODE 07.
2. Press . The cooking time (CODE 40:00) is shown in the display.
3. Press . The display shows CODE COOK CONV.
To set a different cooking time, proceed as follows:
1. Turn , until the display shows CODE 07.
2. Press twice. The display shows ENTER TIME.
3. Turn , until the display shows the desired cooking time.
4. Press . The display shows CODE COOK CONV.
The cooking time last entered will be used for this programme and remains valid until a
new cooking time is entered.
The egg timer function
The timer control can also be used as an egg timer.
Example: you are boiling eggs, and you would like to be reminded that the eggs are
done after 5 minutes.
1. Press 11 times. The display shows MICRO and P-00.
2. Turn , until the display shows 5:00. In addition, ENTER COOK TIME MICRO
appears on the display.
3. Press . The display shows COOK MICRO.
Note: When using the egg-timer function, the microwave oven can be operated
empty, as the power setting is 0%.
Childproof safety device:
This safety device prevents children from operating the appliance without supervision.
To activate the safety device, press for 3 seconds. The LOCK symbol is shown on the
display.
To switch off the safety device, press again for 3 seconds. The LOCK symbol disappears
from the display.
Note: Should you experience a problem switching the appliance on, first verify that the
safety device is not activated.
32
To Next Page
