SEVERIN SM 3775 - Attachment Handling

Whisk
The whisk is suitable for whipping cream
or egg whites or for mixing liquids such as
soups, sauces, etc.
chocolate is also unsuitable.
Close the processing bowl with the lid
and lock it by turning clockwise.
Multi-chopper
Handling of the blender unit
so that
on the drive unit and
on
the blender unit are facing each other.
face each other.
Then lock so that
other.
and
Press
and
Always use a suitable container for
buttons at short
intervals until the material to be sliced
operation. A tall container with a flat
before filling the bowl with the food to be
has reached the desired fineness. Hold
base is best.
chopped.
the lid and the processing bowl.
After chopping, wait until the motor has
stopped before opening the cover or
removing the drive unit. To loosen the
Dip the blender unit into the filled
Avoid overfilling the working tank! The
processing bowl may be filled with herbs
drive unit, turn it until
each other. Unlock the lid, remove it and
take out the blade and the food to be
sliced.
When processing further food after the
by twisting until
other.
mixture before the hand blender is
switched on.
Make sure that the unit can rotate freely
inside the bowl and is not blocked during
operation.
etc. up to the MAX mark.
first cycle, make sure that the receptacle
Push the whisk attachment down into
As soon as the button
the hand blender is switched off. Wait for
the motor to stop before removing the
blender from the food to be mixed.
Do not fill with hot liquids or hard foods
for the blade unit at the bottom of the
bowl is free of food residue before
the ingredients in the bowl before briefly
and
face each
is released,
∙ Remove the mixture after use.
(e.g. ice cubes, nutmegs, cereals, coffee
beans, rice or spices). Hard cheese or
and
face
refitting the unit.
∙
and
face each
switching the unit on with the operation
buttons.
Always wait until the motor has come to
a complete standstill before lifting the
whisk attachment from the mixture.
∙
Place the blender unit on the drive unit
∙
∙
Put the drive unit on the lid of the
processing bowl. Lock by turning so that
∙ ∙
∙
∙
∙
∙
∙
∙
∙
∙
∙
Place the processing bowl on the slip
protection.
Caution: Exercise extreme care: the
blades are very sharp. When handling
the blades, always hold them by the
upper protective plastic covering.
Cut the material to be sliced into pieces
of approximately 1 cm.
Fit the cutting blade unit into the bowl
∙
∙
Insert the whisk into the whisk adapter.
Put the drive unit on the adapter. Lock
∙
∙
∙