in case of any malfunction, -
a er use, and also -
before cleaning the appliance. -
When removing the plug from the wall z
socket, never pull on the power cord;
always grip the plug itself.
No responsibility is accepted if damage z
results from improper use, or if these
instructions are not complied with.
is appliance is intended for domestic or z
similar applications, such as in
sta kitchens, o ces and other -
commercial environments,
agricultural areas, -
hotels, motels etc. and similar -
establishments,
bed-and-breakfast guest houses. -
In order to comply with safety regulations z
and to avoid hazards, repairs of electrical
appliances must be carried out by quali ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service departments. e
address can be found in the appendix to
this manual.
ermal safety cut-out
e preset thermal safety cut-out protects
the heating element from overheating should
the appliance be erroneously switched on
without any water, or if the heating element is
calci ed. Once the safety cut-out has switched
o the kettle, it must be allowed to cool down
su ciently, or must be descaled before it is
switched on again.
Before using for the rst time
For reasons of hygiene, discard the rst three
lling of water.
Boiling water
Never remove the water container from the z
base (or replace it) while the appliance is
switched on.
Remove the water container from its base. –
Take o the lid and ll the container with –
water to the desired level, observing the
Min. and Max. markings.
Replace the lid and put the container back –
on its base, before switching the appliance
on.
Insert the plug into a suitable wall socket –
and press the On/O switch. e indicator
light comes on.
e boiling process begins. A er reaching –
the boiling point, the appliance is
automatically switched o by the integral
steam cut-o device.
e indicator light
goes out.
If you want to interrupt the boiling –
process, set the On/O switch to its O
position.
To pour hot water, remove the container –
from its base.
To prevent hot steam from being emitted, –
ensure that the lid remains closed while
pouring out the water.
Remove the plug from the wall outlet a er –
use.
Do not leave any residual water in the –
container.
Power cord wind-up storage
e wind-up power cord storage under the
base facilitates limiting the length of the
power cord during use and makes it easy to
store the appliance.
Descaling
Depending on the water quality in your area,
lime deposits may build up on the heating plate.
It is advisable to remove any such deposits at
regular intervals. Any warranty claim will
be null and void if the kettle malfunctions
because of insu cient descaling.
A mixture of 0.5 litres of water to two
tablespoons of vinegar essence is suitable.
Pour the descaler in. –
Switch the appliance – on and let the
solution reach boiling point.
Leave it to take e ect for a short period. –
To clean the container a er descaling, –
rinse thoroughly with clean water.
Do not pour descalers down enamel- z
8
To Next Page
Loading...
