SEVERIN ZB 5594 - Page 9

104 x 142 mm
9
attachment and/or the
mixer.
∙ Never let the appliance run
without contents.
∙ Never touch moving parts
of the appliance, risk of
injury!
∙ The appliance must
be switched off and
mains power must be
disconnected before
mounting, changing,
removing accessories or
cleaning the appliance.
Wait for the motor to come
to a complete standstill
after switching off.
∙ The appliance must only be
operated with the original
accessories provided with
it and for the purpose
described.
Before using for the rst time
Clean the attachment before using it for
the rst time, as described in Cleaning and
Care.
Short operation
This appliance is designed with a short
operating time (10 mins), i.e. you can use
it for a maximum of 10 minutes in one go.
Then the unit needs to be switched off for
20 minutes to cool down.
Shaping discs
The shaping discs are numbered for easy
identication:
Spaghetti No. 1
Bucatini No. 2
Tagliatelle No. 3
Pappardelle No. 4
Macaroni No. 5
Rigatoni No. 6
Operation
∙ Select the desired shaping disk and
insert it into the pasta attachment. The
lugs of the shaping disk must lie in the
recesses on the housing.
∙ Hand-tighten the screw ring clockwise
using the handle.
∙ Remove the cover on the front of the
food processor. To do this, reach into the
gap at the bottom of the cover.
∙ Place the pasta attachment on the
appliance and lock it in place by turning
it counter-clockwise. The ller neck must
point upwards.
∙ Place the food tray on the ller neck.
∙ Place a tray under the screw ring.
∙ Insert the power plug into a wall socket.
∙ Set the control knob to the desired
speed level between @ Andreas: 3
and 6.
∙ Only add small amounts of dough to the
ller neck and carefully press down with