SEW-Eurodrive MFE Series - Hybrid Cable Connection

6
Electrical installation
Hybrid cable connection
Manual – EtherCAT
®
Interfaces, Field Distributors
62
6.10 Hybrid cable connection
6.10.1 Hybrid cable between MFZ.3. or MFZ.6. field distributor and MOVIMOT
®
The following figure shows the hybrid cable for connecting the MOVIMOT
®
drive part
number (01867253).
MFZ.6
+
MFZ.3
9007200401506827
The following table shows the terminal assignment of the hybrid cable in the
MOVIMOT
®
connection box:
Terminal assignment
MOVIMOT
®
terminal Wire color/hybrid cable designation
L1 Black/L1
L2 Black/L2
L3 Black/L3
24V Red/24V
⍊ White/0V
RS+ Orange/RS+
RS- Green/RS-
PE terminal Green/yellow + shield end
Note the enabled direction of rotation
Check to see if requested direction of rotation has been enabled.
24V
L
R
Both directions of rotation
are enabled.
L
R
24V
Drive is inhibited or is being
brought to a standstill.
L
R
24V
Only CCW operation is en-
abled.
Setpoint specifications for
CW rotation result in stop-
ping of drive.
L
R
24V
Only CW operation is en-
abled.
Pre-selected setpoints for
CCW rotation result in stop-
ping of the drive.
25809148/EN – 01/2019